I bought a cheap Xbox 360 Wireless Receiver from eBay so I could re-use the wireless pads I have (which also happen to be the best controllers I’ve ever used) with my new PC gaming set up.
The one I ended up with seems a fairly common Chinese import and came with a driver CD (of 32bit drivers) and a very small set of instructions (which didn’t work). Looking at the driver CD it was clear that they were an altered version of the official Microsoft drivers, which suggested that they would be very compatible with the official Microsoft Windows 7 64-bit drivers.
I installed the drivers (I agree, next, next, next) but they didn’t recognise
the adaptor, and I still had an “Unknown Device” under “Other devices” in
Find the device, and select
Update Driver Software:
Yes here, because we know what we’re doing, right?
All of those steps brought the adaptor to life, and I could pair a controller with it and all of the right things happened. After a reboot however, I had to go through all of the installation steps again- it didn’t take too many repetitions before I decided to do something about it.
Editing Windows .INF files for Fun
First, a quick introduction to how Windows pairs up devices and device drivers:
Both USB and PCI busses identify devices by two 16 bit numbers, a vendor ID and a product ID. These are normally displayed as four hexdecimal characters for each number, and you might even see them in the boot-up sequence on some older computers (Intel famously have 8086, which is just rad, as that’s the CPU family that made them rich).
You can view this by clicking on a device’s properties in
Device Manager and
Hardware Ids (sic) property. In this case, they are
It should be noted that
045E is actually Microsoft Corporation, and that this
Far-Eastern knock-off is seriously breaking the rules by re-using another
0291 is not the ID of the official receiver, though,
which is why the device doesn’t just work. The real device is
0719. I don’t
understand why they have done this: if you’re going to clone a device’s USB
identifier, you should probably clone both.
There’s a copy of the Xbox driver files in
C:\Program Files\Microsoft Xbox 360
Accessories - the file we’re going to change now is
Xusb21.INF. This file
lists the installation instructions for the wired and wireless controllers, as
well as the play & charge cable. I can’t reproduce the whole thing, because of
copyright, but excerpting some should be okay:
; Copyright 2006-2007 Microsoft Corporation ; ; XUSB21.INF file ; ; Installs the XUSB21 device driver ; ; Supports the following devices ; Wired Common Controller USB\Vid_045E&Pid_028E ; Wireless Common Controller USB\Vid_045E&Pid_0719 ; Wired CC Compatible USB\MS_COMP_XUSB10 ; Wireless CC Compatible USB\MS_COMP_XUSB20 ; ; Installs a NULL Service for the Play and Charge Cable ; Play and Charge Cable USB\Vid_045E&Pid_028F
Hey, there’s that 0719 we were looking for. All we need to do is search and
replace across the whole file, changing 0719 to 0291. As a cheeky nod to the
knock-off I’m using, I also changed the
XUSB21.DeviceName line, which
dictates what shows up in
The very next time you need to manually update the drivers for this device,
point it at the above folder and it will autodetect your device. It will also
install it into the
Windows DriverStore so you won’t be prompted again. (The
first time, though, you will be asked if you’re okay installing an unsigned
driver- tampering with the .INF file invalidates the digital signature).
[ This post was published Friday, 16 August 2013 ]